Dell Emulex Family of Adapters - Manual (Page 1773)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
Appendix F. Dell UEFI
Main Configuration Page
1773
CHAP Authentication Enable the ability of the initiator to use CHAP authentication when
connecting to the iSCSI target.
Available settings include:
• Enabled
• Disabled (default)
CHAP Mutual Authentication Setting to enable mutual CHAP authentication between the iSCSI
initiator and target.
To use mutual CHAP authentication, specify an initiator secret on
the Initiator Parameters page and configure that secret on the
target.
Available settings include:
• Enabled
• Disabled (default)
IP Version Control whether IPv4 or IPv6 network addressing is used for the iSCSI
initiator.
Available settings include:
• IPv4
• IPv6
• None (default) – Dual mode
Boot to Target Control whether the iSCSI initiator boots to the specified iSCSI target
after connection.
Note: This is only applicable to UEFI iSCSI boot.
Available settings include:
• Enabled
• Disabled (default)
HBA Boot Mode Control whether the iSCSI initiator will boot to the specified iSCSI
target after connection.
Available settings include:
• Enabled (default)
• Disabled
Virtual LAN Mode Enable or disable iSCSI Virtual LAN mode, which allows a VLAN tag to
be used by iSCSI boot.
Available settings include:
• Enabled
• Disabled (default)
Virtual LAN ID Specify the ID (tag) to be used for iSCSI VLAN Mode. The valid range
for the VLAN ID is from 0 to 4095.
Table F-7 iSCSI General Parameters Page Menu Options (Continued)
Menu Option Description and Available Settings