Dell Emulex Family of Adapters - Manual (Page 712)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
Appendix A. Error and Event Log Information
iSCSI Error and Event Log
712
0x138d0101 The iSCSI driver detected an error
offloading the iSCSI connection. The
operation will be retried again.
Following this error log entry, the next
entry will indicate the session handle
and the firmware error code. This may indicate a target is in error or may
point to transient network connectivity issues.
It may also indicate a firmware error.
0x12990013 The iscsi driver did not receive an
iSCSI command window update within
25 seconds during I/O operations.
Following this error log entry, the next
entry will indicate the session handle
where this error occurred. The iSCSI
driver will trigger a session recovery
on the session and continue. • Verify that the iSCSI target is certified by
Microsoft. Check for errors reported at the
target. The Emulex iSCSI UCNA is only
supported with certified targets.
• Check for software updates at the target
vendor's website. If applicable, update the
software.
• Check for software updates at the Emulex
website. If applicable, update the software.
0x127b0012 The iSCSI driver received an invalid
iSCSI Command Sequence Number
update from the target. Following this
error log entry, the next three entries
will indicate the session handle and
the iSCSI parameters – MaxCmdSN and
ExpCmdSN respectively. • Verify that the iSCSI target is certified by
Microsoft. Check for errors reported at the
target. The Emulex iSCSI UCNA is only
supported with certified targets.
• Check for software updates at the target
vendor's website. If applicable, update the
software.
• Check for software updates at the Emulex
website. If applicable, update the software.
0x12790006 A connection to the target was lost for
a period exceeding the ETO. The error
log entry immediately following this
entry will indicate the session ID of
the target that lost the connection.
There will be event log entries from
the disk subsystem indicating that the
drives were lost. If any I/Os were in
progress, the system may see I/O
errors or failures. Check the connection to the target or the state
of the target device. If the target is made
available, any sessions that existed previously
are reestablished and the devices are available
for I/O.
0x11990007 The iSCSI driver received a TMF that is
not supported and rejected this
request. The error log entry
immediately following this entry will
indicate the TMF function code that
was rejected. The operating system version is not supported.
0x11940008 The iSCSI driver received a TMF Abort
request for an I/O request that is not
present with the driver. This may indicate a slow connection to the
target. Check network connectivity to the
target for any errors.
0x1184000B Firmware returned invalid data in its
configuration. iSCSI login and offload
are disabled. Reload the firmware.
Table A-14 iSCSI Error Log Entries on Windows Server 2008 (Continued)
Message ID Message Description/Recommended Resolution