Dell Emulex Family of Adapters - Manual (Page 503)

Offline and Online Adapter Management Utilities Version 10.2 User Manual P010071-01A Rev. A
4. Offline Adapter Management Utility Command Line Interface
Configuration Commands
503
Configuration Commands
Updating Configuration Regions (config)
There are two forms of configuration:

Configure all adapters of a given adapter name at once

Configure a single adapter by its number
Valid region numbers range from 0 to 32.
Update by Name
To update a specified configuration region on all adapters of the same selected name,
type (all on one line)
oslpcfg config a= r= c=
filename>
Note: The adapter name is the name that appears when you run the listHBA
command. For more information on the listHBA command, see “Viewing All
Adapters in the System (listhba)” on page 494.
The following example updates region 6 of all LP11000 adapters with ctplus1.cfl:
oslpcfg config a=lp11000 r=6 c=ctplus1.cfl
The following example updates region 17 of all ABC24-FC56 adapters with
d:\dfplus1.cfl:
oslpcfg config a=ABC24-FC56 r=17 c=d:\dfplus1.cfl
Note: The size of the .cfl file for configuration region update can be up to 2028 bytes.
Update by Number
To update a specified configuration region for one adapter, type (all on one line)
oslpcfg config n= r=
c=
The following example updates region 17 of adapter number 4 with heplus1.cf1:
oslpcfg config n=4 r=17 c=heplus1.cfl
The following example updates region 6 of adapter number 2 with d:\dfplus1.cf1:
oslpcfg config n=2 r=6 c=d:\dfplus1.cfl