Dell Emulex Family of Adapters - Manual (Page 411)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Persistent Binding Commands
411
SetPersistentBinding
This command sets a persistent binding between an FC target and a SCSI bus target.
The binding can be to a target WWPN, target WWNN, or target D_ID.
Supported By
Solaris and Windows
Syntax
SetPersistentBinding
Parameters
BindFlag
The type of binding support for the adapter:
D = Binding by D_ID (not available for Windows driver)
P = Binding by WWPN
N = Binding by WWNN (not available for Windows driver)
A = Binding by automap (not available for Windows driver)
DA = Binding by D_ID and automap
PA = Binding by WWPN and automap
NA = Binding by WWNN and automap
WWPN
The WWPN of an FC or FCoE port.
Scope
P = Permanent binding (survives reboot)
I = Immediate binding
B = Binding is both permanent and immediate
BindType
P = Enable binding by WWPN
N = Enable binding by WWNN
D = Enable binding by D_ID
TargetId
If BindType = P, Target WWPN
If BindType = N, Target WWNN
If BindType = D, Target D_ID
SCSIBus
The bus number of the SCSI device.
SCSITarget
The target number of the SCSI device.