Dell Emulex Family of Adapters - Manual (Page 356)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Diagnostic Commands
356
EchoTest
This command runs the echo test on FC adapters.
Notes

This command is only supported on FC and FCoE ports.

The EchoTest command fails if the target WWPN does not support the ECHO
ELS command.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
EchoTest
Parameters
GetBeacon
This command shows the current beacon state (either “on” or “off”).
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
GetBeacon
Parameters
WWPN Source
The WWPN of the originating adapter.
WWPN Destination
The WWPN of the destination (echoing) adapter.
Count
The number of times to run the test. Use “0” to run the test
indefinitely.
StopOnError
Checks if the test must be halted on error:
0 = No halt
1 = Halt on error
Pattern
Hexadecimal data pattern to transmit (up to 8 characters).
WWPN
The WWPN of the adapter.
MAC
The MAC address of the NIC or iSCSI port.