Dell Emulex Family of Adapters - Manual (Page 235)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
OCe14000-Series Adapters
235
PFC Properties Area

State – Enabled means that flow control in both directions (Tx and Rx) is
enabled. State – Enabled means that flow control in both directions (Tx and Rx)
is enabled. Disabled means that priority-flow control is currently disabled. The
priority value, if Shown, is not applicable. This may be caused by:

The switch port priority-flow control being set to On instead of Auto

Switch port using port flow control instead of priority flow control

PFC disabled at adapter or switch

Active Priorities – Lists the priorities with PFC set to Enabled.

Sync’d – If yes, the PFC priorities have been set by the peer. This parameter
cannot be set.

Error – The error state. This capability indicates whether an error has occurred
during the configuration exchange with the peer. Error is also set to YES when
the Compatible method for the capability fails.
Properties Area

State – The iSCSI or FCoE state. It can be Enabled or Disabled.

Active Priority – The current active priority assigned for iSCSI or FCoE.

Sync’d – If yes, the iSCSI or FCoE priority has been set by the peer. This
parameter cannot be set.

Error – The iSCSI or FCoE error state. This capability indicates whether an error
has occurred during the configuration exchange with the peer. Error is also set
to YES when the Compatible method for the capability fails.
ETS Priority Group Properties Area
Note: Not displayed when multichannel is enabled on the adapter with the exception
of NPar.

State – The current Priority Group state. It can be Enabled or Disabled.

Sync’d – If yes, the Priority Groups have been set by the peer. This parameter
cannot be set.
Note: When NPar is enabled and Sync'd is set yes, the protocols are limited to
the bandwidths shown in the Priority Groups instead of the bandwidths
configured in the Adapter Configuration tab.

Error – The error state. This capability indicates whether an error has occurred
during the configuration exchange with the peer. Error is also set to yes when
the Compatible method for the capability fails.
Active Groups

PG – The Priority Group number. It can be 0 to 7.

Priorities – The priorities that are assigned to each Priority Group. It is
represented in comma separated format.