Cmmode, Cmsetbw – Dell Emulex Family of Adapters User Manual
Page 1339
OCM for VMware vCenter Version 10.2 User Manual
P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1339
cmmode
Syntax
elxvcpcmd.exe v=
h=
Description
This command enables or disables channel management on an adapter.
Note: A system reboot is required for the change to take effect.
Parameters
Example:
This example shows that the channel management on an adapter containing a NIC
function with a MAC address of [00-00-c9-ad-ad-aa] is disabled.
elxvcpcmd.exe v=10.20.30.40 u=username p=password h=10.11.12.13 CMMode
00-00-c9-bb-cc-aa None
cmsetbw
Note: This command is not available for 1 Gb ports.
Syntax
>elxvcpcmd.exe v=
h=
Description
This command sets the minimum and maximum bandwidth for up to N channels each
on the physical port (where N is number of channels enabled on the adapter). The total
of the minimum bandwidths must add up to 100%. The total of the maximum
bandwidths must be greater than or equal to the minimum bandwidths and have a
maximum of 100%. When only three channels are available, specifying Min3,Max3
causes an error. When only two channels are available, specifying Min2,MaxB2 and
Min3,Max3 causes an error.
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
WWPN
WWPN of an FCoE function on the physical port.
MAC
MAC address of any NIC function on the physical adapter port.
None|Type
Specify None to disable channel management or specify a channel
management type to enable channel management.