Configuring boot from san for the fcoe protocol, Configuring boot from san on windows (x64), Configuring boot from san for the fcoe protocol 8 – Dell Emulex Family of Adapters User Manual

Page 1558: Chapter 4., “configuring boot from

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual

P010097-01B Rev. A

4. Configuring Boot from SAN for the FCoE Protocol

Windows Server 2008, Windows Server 2012, and Windows Server 2012 R2

1558

4. Configuring Boot from SAN for the FCoE

Protocol

When booting from SAN, the storage device is typically identified by its WWPN and a

LUN. By extending the server system BIOS, boot from SAN capability is provided by

the boot BIOS contained on an Emulex adapter in the server. When properly

configured, the adapter then permanently directs the server to boot from a logical unit

(disk) on the SAN as if it were a local disk.

Note: Not all procedures are required. Emulex adapters usually ship from the factory

with the latest version of boot code installed and enabled, so you do not need to

install or enable boot code in those cases. However, if boot code is not enabled,

you must enable it. You may want to update the boot code if a more current

version is available on the Emulex website at http://www.emulex.com.

This section describes how to set up a system to boot from SAN. This specific procedure

to follow is determined by the system architecture and the operating system.

Windows Server 2008, Windows Server 2012, and
Windows Server 2012 R2

Configuring Boot from SAN on Windows (x64)

To configure boot from SAN:
1. If necessary, update the boot code on the adapter. See chapter 7., “Updating and

2. If necessary, enable the boot code on the adapter. See chapter 7., “Updating and

on page 1579 for more information.

information.

5. If desired, configure the boot options on the adapter. See “Configuring Advanced

6. Install the operating system on a boot disk.