Dell Emulex Family of Adapters - Manual (Page 405)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Miscellaneous Commands
405
Parameters
SetPfcThrottle
This command returns the PFC throttle state as enabled or disabled.
Note: The PFC throttle state is returned when using the PortAttributes command for
OneConnect OCe10102 adapters. However, for OneConnect adapters with
older firmware that does not support PfcThrottle and for non-OneConnect
adapters, the PFC throttle state is not returned when using the PortAttributes
command.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetPfcThrottle <0|1>
Parameters
SRIOVEnable
This command enables or disables SR-IOV on a specified NIC port (that is, physical
function).
Notes:

This command is not available on OCe11101-EM/EX or OCe11102-EM/EX
adapters. The following error will be returned:
ERROR: <251>: Hardware or firmware does not support command.

SR-IOV is not supported with RoCE configurations.

SR-IOV is not supported with UMC commands or channel management
commands.
username
Login User ID of the VMware ESXi.
password
The login password of the VMware ESXi.
namespace
The namespace where the Emulex provider is registered in the SFCB
CIMOM of VMware ESXi, specifically “root/emulex”.
portnum
The port number of the SFCB CIMOM listening to, that is, 5988 (HTTP) or
5989 (HTTPS).
WWPN
The WWPN of an FC or FCoE port.
0|1
The PFC throttle state:
0 = Disabled
1 = Enabled