Dell Emulex Family of Adapters - Manual (Page 1390)

OCM for VMware vCenter Version 10.2 User Manual P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1390
updateisnsserver
Syntax
elxvcpcmd.exe v= u= p=
h= updateisnsserver
Description
This command updates the configured iSNS server. This command requires the server
IP and port number of the iSNS server be available to respond to
the iSNS requests.
Parameters
VEPAenable
Note: VEPA is only supported on OCe14000-series NIC ports. For all other adapter
types and port types this feature is undefined, and this command returns the
following error message: Hardware Does Not Support.
Syntax
elxvcpcmd.exe v= u= p= h=
VEPAenable <0|1>
Description
The command takes two parameters:

The MAC address is the MAC address of any NIC on the relevant physical port.

The final parameter specifies whether to enable or disable VEPA: 0 is disabled
and 1 is enabled.
Parameters
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.
MAC
The MAC address of the iSCSI port.
Server_IP
IP address of the iSNS server to configure.
Port
Port number of the iSNS server to configure (value: 1024-65535).
v
The vCenter server IP address.
u
The user name for the vCenter server.
p
The user password for the vCenter server.
h
The IP address of the ESXi host with Emulex adapters.