Dell Emulex Family of Adapters - Manual (Page 1593)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
6. Using the FCoE Boot BIOS Utility for x86 and x64 Architectures
Resetting to Default Values
1593
The order of boot entries exported to Multi-boot (BBS) is
boot_entry0, boot_entry1, boot_entry2, and boot_entry3.
However, Multi-boot allows changing the boot order in the server BIOS, which allows
any disk to become the C drive.
Resetting to Default Values
The BIOS utility enables you to reset BIOS boot parameters to their factory default
settings. These defaults are listed in Table 6-2.
Table 6-2 Default Adapter Boot Parameter Values
Parameter Default Value Valid Values
Boot from SAN Disabled Enabled
Disabled
AL_PA Value 0x00 Fibre See Table 6-1, Valid AL_PA Values.
EDD 3.0 Enabled (EDD 3.0) Enabled (EDD 3.0)
Disabled (EDD 2.1)
PLOGI Retry Timer Disabled Disabled
50 msec
100 msec
200 msec
Spinup Delay Disabled Enabled
Disabled
Auto Scan Disabled Enabled
Disabled
Start Unit Disabled Enabled
Disabled
Environmental Variable Disabled Enabled
Disabled
Auto Boot Sector Disabled Enabled
Disabled