Dell Emulex Family of Adapters - Manual (Page 1242)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
6. Managing Adapters and Ports
iSCSI Port
1242

Transmit Port Description Enabled – Provides a description of the port in an
alpha-numeric format. The value equals the ifDescr object, if the LAN device
supports RFC 2863.

Transmit System Name Enabled – Provides the system's assigned name in an
alpha-numeric format. The value equals the sysName object, if the LAN device
supports RFC 3418.

Receive Enabled – LLDP Receive can be enabled or disabled.

Transmit System Description Enabled – Provides a description of the network
entity in an alpha-numeric format. This includes system's name and versions of
hardware, operating system and networking software supported by the device.
The value equals the sysDescr object, if the LAN device supports RFC 3418.

Transmit System Capabilities Enabled – Indicates the primary function(s) of the
device and whether these functions are enabled on the device. The capabilities
are indicated by two octets. Bits 0 through 7 indicate Other, Repeater, Bridge,
WLAN AP, Router, Telephone, DOCSIS cable device and Station respectively.
Bits 8 through 15 are reserved.
PFC Priorities Area
Note: There is no PFC support for an OCe10100–series adapter’s NIC or iSCSI port.

Active Priorities – The priorities that are marked active for PFC.

Enable – When checked, PFC is enabled.

Configured Priorities –The priorities that are configured, but might not yet be
active. A maximum of two PFC priority checkboxes can be selected, out of
which one of these selections must match the iSCSI priority. The additional PFC
priority is for Ethernet traffic. The PFC priority for Ethernet traffic must be
assigned to a Priority Group which has no other priorities.
iSCSI Priority Area

Active Priority – The active iSCSI priority.

Configured Priority – The configured iSCSI priority.
ETS Priority Groups Area
Note: Not available when UMC is enabled on the adapter.

Active Groups

Group ID – The Priority Group ID.

Priority Membership – The different priorities assigned to the various
Priority Groups. This is the current active configuration.

Bandwidth – The bandwidths that are assigned to different Priority Groups.
This is the current active configuration.

Configured Groups

Group ID – The Priority Group ID.

Priority Membership – The configured priority membership grouping.