Dell Emulex Family of Adapters User Manual
Page 334
OneCommand Manager Command Line Interface Version 10.2 User Manual
P010067-01A Rev. A
5. CLI Client Command Descriptions
Attributes Commands
334
to a range of values for auto-negotiation with the switch, for example
10Gb/1Gb/100Mb. There are three values that can be configured - port speed mode,
speed value(s), and the DAC cable length.
The configurable port speeds are based upon the port module type and the mode
defined by port speed Mode parameter. For the “Default” port speed Mode, the speed
setting is not required.
Note: 10GB CX4, 10GB XFP and SGMII port module types do not support port speed
settings.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetPhyPortSpeed
Parameters
WWPN
The WWPN of an FCoE port.
MAC
The MAC address of a NIC or iSCSI port.
Mode
The Mode number:
0 = Default
1 = Auto-negotiate; requires the Speed parameter
2 = Force; requires the Speed and Length parameters
Note: When the adapter's port speed setting and the switch's port speed setting conflict, the
link will not be brought up.
Speed
The speed string of the PHY port. Some valid string values include “100Mb”,
“1Gb”, and “10Gb”. The PortAttributes command lists all the valid speeds in
Auto-negotiate and Force modes.
Auto-negotiated Speeds
A comma-separated list of available auto-negotiated speeds is displayed by
the PortAttributes command for OneConnect OCe11100-series and
OCe14000-series adapters. For combinations of speeds, each speed is
separated by a slash, for example, 10Gb/1Gb/100Mb. If the port does not
support auto-negotiated speeds this property will be displayed as "Not
Supported".
Forced Speeds
A comma-separated list of available forced speeds is displayed by the
PortAttributes command for OneConnect OCe11100-series and
OCe14000-series adapters. There are no combinations of speeds for forced
speeds. If the port does not support forced speeds this property will be
displayed as "Not Supported".
Note: When the Mode parameter is 1 or 2, the Speed parameter is required. When the Mode
parameter is 0, the Speed parameter is ignored.