Dell Emulex Family of Adapters - Manual (Page 717)

Emulex Drivers for Windows User Manual P010077-01A Rev. A
Appendix A. Error and Event Log Information
iSCSI Error and Event Log
717
0x1b Warning A configuration parameter is
out of range. The iSCSI driver failed to load a configuration
value specified in the registry because the
value was out of range. The driver uses the
default value for this configuration parameter.
The range specified for a configuration
parameter is either too large or too small, and
it must be corrected. Check the registry
configuration for new driver parameter entries.
See Table 3-12, iSCSI Driver Options, on
page 662 for the correct range of values
0x1d Warning A configuration parameter is
invalid. The iSCSI driver ignored a configuration entry
because the entry was invalid.
Check the registry configuration for new driver
parameter entries. The invalid entry must be
removed or corrected.
See Table 3-12, iSCSI Driver Options, on
page 662 for the correct range of values.
0x1e Error Failed to map Base Address
Register, failing driver load. The iSCSI driver was unable to load because it
was unable to map one or more PCI Base
Address registers.
This failure may indicate a low memory
condition or a hardware error.
0x1f Error Hardware initialization has
failed – error code A. The hardware initialization has failed. This
error causes the driver load to fail. The error
code included in the event log entry identifies
the specific point of failure.
This failure indicates that the hardware has not
been initialized or is malfunctioning. This may
also indicate that the firmware is not running
correctly.
0x20 Warning Initial memory allocation
failed, driver is running with
reduced capabilities. The driver failed to allocate its complete
memory requirement and attempts to load with
reduced capabilities. The total number of
targets available is reduced.
This message indicates a low memory
condition.
0x21 Info Target Reconnected for
Session id N. N/A
0x22 Info Interrupt Redirection
capability is enabled. N/A
0x23 Warning Interrupt Redirection
capability is not supported by
this firmware. Update your
firmware. Update the firmware to the latest version.
Table A-15 iSCSI Error Log Entries on Windows 7, Windows 8, Windows 8.1, Windows Server 2008 R2, Windows
Server 2012, and Windows Server 2012 R2 (Continued)
Message ID Severity Message Recommended Resolution