Dell Emulex Family of Adapters - Manual (Page 1414)

Boot for the Fibre Channel Protocol User Manual P010096-01A Rev. A
2. Boot from SAN
Solaris
1414
Example 3: did=6312200, lun=25 (hexadecimal) and target id=f (hexadecimal):
did 6312200 25 f set-boot-id
5. Boot to the original local disk to set up the newly defined FC disk. Type
boot local_disk
where local_disk is the complete path or the alias of the original boot disk.
Note: If the FC disk is not found when the system is rebooted, enter
touch
/
reconfigure and reboot. If the disk is still not discovered, edit the
/kernel/drv/lpfc.conf file and change the topology from 4 to 2 (or from 2 to
4). It may also be necessary to add an entry for the boot drive to the sd.conf
file.
6. Run the format utility:
format
7. Select the target disk to become the new boot disk (for example, c1t1d0).
8. Select the partition option and partition the disk as desired.
9. Select the label option and write a volume label to the target disk.
For help with the format utility, see the man page “man format”.
10. Install the boot on partition 0 of the target disk. (Type this command as one line.)
installboot /usr/platform/ `uname -i`/lib/fs/ufs/bootblk /dev/rdsk/clt1d0s0
11. Create a filesystem for each partition that contains a mounted filesystem:
newfs -v /dev/rdsk/clt1d0s0 (becomes root)
newfs -v /dev/rdsk/clt1d0s6 (becomes usr)
newfs -v /dev/rdsk/clt1d0s7 (becomes export/home)
12. Create temporary mount points for the new partitions:
mkdir root2
mkdir usr2
mkdir export2
13. Mount, copy, then unmount the usr2 file system:
mount /dev/dsk/clt1d0s6 /usr2
c0t0d0s6 ufsdump 0f - /dev/rdsk/c0t0d0s6 | (cd /usr2; ufsrestore rf -)
umount /usr2
14. Copy the export/home file system:
mount /dev/dsk/clt1d0s7 /export2
ufsdump 0f - /dev/rdsk/c0t0d0s7 | (cd /export2; ufsrestore rf -)
umount /export2
15. Perform copy:
mount /dev/dsk/clt1d0s0 /root2
ufsdump 0f - /dev/rdsk/c0t0d0s0 | (cd /root2; ufsrestore rf -)
16. Edit /root2/etc/vfstab, changing the controller number, target number and LUN
number to point to the new FC boot disk. For example, if the FC boot disk is c1t1d0,
replace all local disk entries of c0t0d0 with c1t1d0.
Currently the file shows: