Dell Emulex Family of Adapters - Manual (Page 851)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
3. Configuration
iSCSI Driver Configuration
851
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:218 Memory:f6000000-f6012800
eth4 Link encap:Ethernet HWaddr 00:00:C9:F2:73:8C
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
eth5 Link encap:Ethernet HWaddr 00:00:C9:F2:73:90
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:42 errors:0 dropped:0 overruns:0 frame:0
TX packets:75 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:11738 (11.4 KiB) TX bytes:10590 (10.3 KiB)
5. Use the ethtool to find the interface on the Ethernet adapter for which the link is up.
ethtool eth5
Example output:
Settings for eth5:
Supported ports: [ FIBRE ]
Supported link modes: 10000baseT/Full
Supports auto-negotiation: No
Advertised link modes: Not reported
Advertised auto-negotiation: No
Speed: 10000Mb/s
Duplex: Full
Port: FIBRE
PHYAD: 1
Transceiver: external
Auto-negotiation: off
Supports Wake-on: g
Wake-on: d
Link detected: yes
6. Set the IP address for the Ethernet interface.
ifconfig eth5 192.168.65.10 up
7. Display the ifaces that are present.
iscsiadm -m iface
Example output:
default tcp,,,,
iser iser,,,,
bnx2i.00:25:b3:df:8d:ad bnx2i,00:25:b3:df:8d:ad,,,