Adding a vlan – Dell Emulex Family of Adapters User Manual

Page 802

OneCommand NIC Teaming and VLAN Manager User Manual

P009415-01A Rev. A

5. OneCommand NIC Teaming Manager Command Line Interface

The Command Reference

802

Parameters

Description

This command removes the specified adapter from the specified team. The adapter can

only be removed if the team will be left with the minimum number of adapters for that

team type.

Example

c:\Program Files\Emulex\NIC Teaming>octeamcmd.exe delete adapter myteam nic5

Adapter nic5 has been successfully deleted from team FOTeam

Adding a VLAN

The following notes apply to adding a VLAN:



Adapters, teams and VLANs that have been disabled in Network Connections

or Device Manager cannot be managed by the NIC Teaming Manager and may

not be visible to the NIC Teaming Manager. Make sure that any affected

adapters, teams and VLANs are enabled before making any NIC Teaming

configuration changes.



If you use static IP addresses (non-DHCP), you must assign IP addresses to any

native VLANs and VLANs that you create.



When the first VLAN is added to a team, the team's Native VLAN is removed.

The Native VLAN can be added later, if desired. If the Native VLAN is added

again, adding additional VLANs will not affect its state. For more information



VLANs created over teams containing non-Emulex team members are not

supported by Emulex. However this configuration may work if the non-Emulex

team members are well-known to your system. Discretion is advised.

Syntax

add vlan <team-id |adapter-id> < vlan-id> {number}

team-id

Team from which an adapter is to be removed.

adapter-id

Adapter to be removed.