Dell Emulex Family of Adapters - Manual (Page 134)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
FC/FCoE
134

Change Settings – Click to enable or disable automapping, choose a bind type
and enable or disable LUN mapping and unmasking. (Not available on
VMware ESXi servers being managed through the CIM interface.)

Add Binding – Click to add a persistent binding.

Bind New Target – Click to add a target that does not appear in the Persistent
Binding table.

Remove – Click to remove the selected binding.

Remove All Bindings – Click to remove all persistent bindings that are
displayed.
Viewing Target Mapping (Linux and VMware ESXi)
Use this tab to view target mapping. The Target Mapping tab is read-only.
Note: Persistent binding is not supported by the Linux 2.6 kernel, the Emulex 8.2
version of the driver for Linux, or by VMware ESXi Server.
To view target mapping:
1. Select Host or Fabric view.
2. Select the adapter port in the discovery-tree whose target mapping information you
want to view.
3. Select the Target Mapping tab.
Target Mapping Field Definitions
Current Settings Area

Active Bind Type – N/A

Automapping – N/A
Current Mappings Area

This table lists current mapping information for the selected adapter.
Persistent Binding Configuration Area

N/A
Display Mode Radio Buttons

N/A
Target Mapping Buttons

N/A
Using Automapping and Persistent Binding (Windows)
Set up persistent binding on remote and local adapters. Global automapping assigns a
binding type, target ID, SCSI Bus and SCSI ID to the device. The binding type, SCSI Bus