Dell Emulex Family of Adapters - Manual (Page 242)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
OCe14000-Series Adapters
242

Maximum Version – The highest DCBX protocol version supported by the
system. Version numbers start at zero. The DCBX protocol must be backward
compatible with all previous versions. This setting cannot be changed.
LLDP Settings Area

Transmit Enabled – LLDP Transmit can be enabled or disabled.

Transmit Port Description Enabled – Provides a description of the port in an
alpha-numeric format. The value equals the ifDescr object, if the LAN device
supports RFC 2863.

Transmit System Name Enabled – Provides the system's assigned name in an
alpha-numeric format. The value equals the sysName object, if the LAN device
supports RFC 3418.

Receive Enabled – LLDP Receive can be enabled or disabled.

Transmit System Description Enabled – Provides a description of the network
entity in an alpha-numeric format. This includes the system's name and
versions of hardware, operating system and networking software supported by
the device. The value equals the sysDescr object, if the LAN device supports
RFC 3418.

Transmit System Capabilities Enabled – Indicates the primary function(s) of the
device and whether or not these functions are enabled on the device. The
capabilities are indicated by two octets. Bits 0 through 7 indicate Other,
Repeater, Bridge, WLAN AP, Router, Telephone, DOCSIS cable device and
Station respectively. Bits 8 through 15 are reserved.
PFC Priorities Area

Active Priorities – The priorities that are marked active for PFC.

Enable – When checked, PFC is enabled.

Configured Priorities – The priorities that are configured, but might not yet be
active. Only the RoCE priority should be selected.
RoCE Priorities Area

Active Priorities – The priority that is marked active for RoCE.

Configured Priorities – The priorities that are configured, but might not yet be
active.
ETS Priority Groups Area

Active Groups

Group ID – The Priority Group ID.

Priority Membership – The different priorities that are assigned to the
various Priority Groups. This is the currently active configuration.

Bandwidth % – The bandwidths that are assigned to different Priority
Groups. This is the currently active configuration.

Configured Groups

Group ID – The Priority Group ID.