Dell Emulex Family of Adapters - Manual (Page 1709)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
13. Configuring UEFI for FCoE
Resetting Emulex Adapters to Default Values
1709
4. Use the +/- keys to change the delay device discovery value in increments of 10
seconds and press . The screen is refreshed with the modified value.
5. Select Commit Changes and press . The Emulex Adapter Configuration
Main Menu is displayed.
Resetting Emulex Adapters to Default Values
The EFI utility enables you to clear the NVRAM target list and set all boot device
WWNNs back to 0, along with setting the adapter back to the default values. These
default values are listed in Table 13-1.
Table 13-1 Adapter Default Values
Parameter Default Value Valid Values
Enable/Disable BIOS Disabled Enabled
Disabled
PLOGI Retry Timer Disabled Disabled
50 msec
100 msec
200 msec
Boot Target Scan Boot path from NVRAM targets Boot path from NVRAM targets
Boot path discovered targets
Do not create boot path
Maximum LUNs Setting 0256 0–4096
Delay Device Discovery 0000 0000–0255
Advanced Mode Enabled (OCe11100-series and the
LPe16202/OCe15100 CFA)
Disabled (OCe10100-series controllers) Enabled
Disabled
PXE Boot Support The default for this parameter varies
depending on the vendor
configuration. Enabled
Disabled
SR-IOV Disabled Enabled
Disabled
VLAN Support Disabled Enabled
Disabled
VLAN ID 0 0–4094
VLAN Priority 0 0–7
Multichannel Support The default for this parameter varies
depending on the vendor
configuration. Enabled
Disabled
Function En/Dis Disabled Enabled
Disabled