Dell Emulex Family of Adapters - Manual (Page 1264)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
6. Managing Adapters and Ports
OCe10100–Series and OCe11100–Series Adapters
1264
Change Port Speed Field Definitions

Mode

Default – Speed and DAC Cable Length fields are not active.

Force

Auto-Negotiate

Speed – This field is active if the mode is set to Force or Auto-Negotiate.

If the mode is set to Force and depending upon the interface type, you can
set the speed to one of the following:

10 Mb

100 Mb

1 Gb/s

10 Gb/s

If the mode set to Auto-Negotiate, and depending upon the interface type,
you can set the speed setting to a single or multiple speed value.

Single speed values

10 Mb

100 Mb

1 Gb/s

10 Gb/s

Multiple speed values combinations

10 Gb/s and 1 Gb/s

1 Gb/s and 100 Mb

1 Gb/s, 100 Mb and 10 Mb

100 Mb and 10 Mb

DAC Cable Length – This field is only required if the Force mode is selected and
the speed is set to 10 Gb/s. Select from 1 to 10 meters. This field is not active in
all other cases.
Viewing Physical Data for OneConnect 10GBASE–T–Series
Adapters
The PHY Data tab shows physical data information for OneConnect 10GBASE-T–series
adapters.
To view physical data information:
1. Select a host in the vSphere console tree-view and select the Emulex OneCommand
tab.
2. In the Emulex Device Management tree-view, select the physical port for which you
want to view physical data information.
3. Select the PHY Data tab.