Dell Emulex Family of Adapters - Manual (Page 920)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
920
0749: SCSI layer issued abort device
The SCSI layer aborted a device.
Data: (1) ret, (2) id, (3) lun, (4) snum
Severity: Warning
Log:
LOG_FCP verbose
Action: None required.
0915 Register VPI failed:
Could not register the VPI.
Data: None
Severity: Error
Log:
LOG_MBOX
Action: None required.
1005: AUTHENTICATION_FAILURE Nport:
The system detected DHCHAP authentication failure on a port.
Data: (1) nlp_DID
Severity: Error
Log:
LOG_SECURITY
Action: Verify authentication settings and keys on local and remote port.
1006: Bad Name tag in auth message < message >
DHCHAP Authentication process failed when invalid tag was detected.
Data: (1) message
Severity: Error
Log:
LOG_SECURITY
Action: Software driver Error. If this issue persists, report errors to the Technical Support.
1007: Bad Name length in auth message < message >
DHCHAP Authentication process failed when invalid name was detected.
Data: (1) message
Severity: Error
Log:
LOG_SECURITY
Action: Software driver Error. If this issue persists, report errors to the Technical Support.
1008: Bad Number of Protocols
DHCHAP Authentication process failed due to unexpected protocol number.
Data: (1) message
Severity: Error
Log:
LOG_SECURITY
Action: Software driver Error. If this issue persists, report errors to the Technical Support.
1009: Bad param type
DHCHAP Authentication process failed when invalid protocol was detected.
Data: (1) message
Severity: Error
Log:
LOG_SECURITY
Action: Software driver Error. If this issue persists, report errors to the Technical Support.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)