Dell Emulex Family of Adapters - Manual (Page 896)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
896
0334: Unknown IOCB command
Received an unknown IOCB command completion.
Data: (1) type (2) ulpCommand (3) ulpStatus (4) ulpIoTag (5) ulpContext)
Severity: Error
Log:
Always
Action: This error could indicate a software driver or firmware issue. If this issue persists, report
these errors to Technical Support.
0335: Unknown IOCB command
Received an unknown IOCB command completion.
Data: (1) ulpCommand (2) ulpStatus (3) ulpIoTag (4) ulpContext)
Severity: Error
Log:
Always
Action: This error could indicate a software driver or firmware issue. If this issue persists, report
these errors to Technical Support
0336: Rsp Ring error: IOCB
An IOCB error has occurred on the specified ring.
Data: (1) ulpWord[0], (2) ulpWord[1], (3) ulpWord[2], (4) ulpWord[3], (5) ulpWord[4], (6)
ulpWord[5], (7) irsp+6, (8) irsp+7
Severity: Warning
Log:
LOG_SLI verbose
Action: If this issue persists, check the targets. If the targets are okay, report the error to
Technical Support.
0340: Adapter temperature is OK now
Adapter temperature has reverted to normal range.
Data: Temperature in Celsius
Severity: Error
Log:
LOG_TEMP verbose
Action: No action needed, informational
0341: Ring Cannot find buffer for an unsolicited iocb tag
There are no more pre-allocated buffers available to handle unsolicited buffers.
Data: None
Severity: Error
Log:
LOG_SLI
Action: Ensure this port is not being managed by multiple ports.
0342: Ring Cannot find buffer for an unsolicited iocb tag
This is a multiple IOCB unsolicited command and sufficient buffer space cannot be allocated for it.
Data: None
Severity: Error
Log:
LOG_SLI
Action: None required.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)