Dell Emulex Family of Adapters - Manual (Page 927)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
927
1227: FCoE IOCB TMO: handler set for
The management command for the LPFC 2100 has timed out.
Data: None
Severity: Warning
Log:
LOG_LIBDFC
Action: None required.
1228: FCoE IOCB TMO: handler set for
A management IOCB for the LPFC 2100 has timed out
Data: None.
Severity: Warning
Log:
LOG_LIBDFC
Action: None required.
1229: Waiting for menlo mnt
Waiting for the LPFC 2100 to enter maintenance method.
Data: None.
Severity: Warning
Log:
LOG_LIBDFC
Action: None required.
1230: Could not find buffer for FCoE cmd:off <#> indmp off <#>
Could not find resources associated with this FCoE command.
Data: (1) current offset (2) buffer desc pointer (3) size.
Severity: Error
Log:
LOG_LIBDFC
Action: Try reloading the driver when convenient.
1231: bad bpl:
A invalids buffer list was detected upon completion.
Data: None.
Severity: Error
Log:
LOG_LIBDFC
Action: None required.
1235: Could not find buffer for FCoE cmd: off:<#> poff:<#> cnt:<#> mlastcnt:<#>
addl: addh: mdsz:<#>
FCoE command failed because it could not find the resource.
Data: (1) current offset (2)previous offset (3) count (4) last count (5) address low (6) address
high
Severity: Error
Log:
LOG_LIBDFC
Action: No action needed, informational.
1238: FCoE IOCB failed: off <#> rc=<#>
The command generated by the driver to check the FCoE has failed.
Data: (1) offset (2) return code
Log: LOG_LIBDFC
Severity: Error
Action:
Make sure link is up or the adapter has set menlo in maintenance mode.
Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)