Dell Emulex Family of Adapters - Manual (Page 400)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Miscellaneous Commands
400
Download
Loads the firmware image to the port specified by the WWPN or MAC address.
Notes

For 16-Gb HBA firmware downloads, the OneCommand Manager application
only accepts “.grp” files.

For OneConnect and 16-Gb HBAs, while the WWPN or MAC address is used to
identify the adapter, the updated firmware applies to all ports on that adapter.
It is not necessary to download the firmware on all the adapter ports of a
OneConnect adapter or a 16-Gb HBA.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
Download
Parameters
ExportSANInfo
For reporting purposes, this command captures the SAN information in “.xml” for
XML-formatted files and “.csv” for CSV-formatted files. Since this command can
output a large amount of information, it is recommended that you re-direct the output
to a file.
Note: Due to the amount of information that must be obtained and reported, this
command can take a long time on large SAN configurations.
Supported By
Linux, Solaris, and Windows
Syntax
ExportSANInfo [format]
Note: The “h=” option (for specifying an optional IP address or host name) after
“hbacmd” is not available for the ExportSANInfo command.
WWPN
The WWPN of an FC or FCoE port.
MAC
The MAC address of a NIC or iSCSI port.
FileName
The name and location of the firmware image (any file accessible to the CLI
client).