Dell Emulex Family of Adapters - Manual (Page 506)

Offline and Online Adapter Management Utilities Version 10.2 User Manual P010071-01A Rev. A
4. Offline Adapter Management Utility Command Line Interface
Running Tests
506
Running the Internal Loopback Test (intloopback)
This command runs the internal loopback test. You can run the test on a specific
adapter in the system. Specify the number of times you want the test to repeat, and
direct the test response if an error occurs.
The option on error choices are:

o=1 stops the test on the first error

o=2 ignores three errors and stops the test on the fourth error

o=3 ignores errors and continues the test
Notes:

intloopback does not support testing all installed adapters using n=all.

Do not use the internal loopback test on Emulex blade adapters.
To run the internal loopback test, type (all on one line)
oslpcfg intloopback n= r= o=
error>
To run internal loopback test on OneConnect adapters, type (all on one line)
oslpcfg intLoopback n= p= c=
r= t=
where:

p = 3 to 8-HEX byte pattern

c = 1500 to 8192

r = 1 to 4096

t = 2
The following example runs the internal loopback test 100 times on adapter #1 and
stops the test if an error occurs:
oslpcfg intloopback n=1 r=100 o=1
Running the PCI Loopback Test (pciloopback)
This command runs the PCI loopback test. You can run the test on a specific adapter or
on all adapters in the system. Specify the number of times you want the test to repeat,
and direct the test response if an error occurs.
The option on error choices are:

o=1 stops the test on the first error

o=2 ignores three errors and stops the test on the fourth error

o=3 ignores errors and continues the test
Note: pciloopback does not support testing all installed adapters using n=all.