Dell Emulex Family of Adapters - Manual (Page 419)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Profile Management Commands
419
Syntax
ListProfiles
Parameters
Example
Note: Different adapter models will have a different set of profiles.
>hbacmd ListProfiles 00-00-c9-12-34-56
Active Profile ID: 23
Configured Profile ID: 23
Available Profiles
ID Description
-- ----------------------------------
16 NIC
17 ISCSI initiator, no DIF
19 FCOE initiator + Target, with DIF
20 RoCE-1
21 RoCE-2
23 FCOE initiator + Target, no DIF
24 NIC - ETS Disabled
36 Mixed Storage, 25% ISCSI initiator only, 75% FCOE, no DIF
37 Mixed Storage, 50% ISCSI initiator only, 50% FCOE, no DIF
38 Mixed Storage, 75% ISCSI initiator only, 25% FCOE, no DIF
SetAdapterPortConfig
This command configures the function protocol assignments for all ports on an
OCe14000-series adapter. It can also be used to restore the adapter to its factory default
profile and settings.
The number of ports and function protocol assignments specified in this command
depends upon the available ports, storage mode (mixed or concurrent), and
multichannel and NPar state.
To support up to sixteen functions on an adapter, ARI must be available on the system
with the following conditions: the system hardware, such as the motherboard and
BIOS, must support ARI, ARI must be enabled in the system BIOS, the operating
system must support ARI, such as the Windows Server 2012 and later, and any
management tools that you use must support ARI, such as OneCommand Manager
MAC
MAC address of any NIC, NIC+RoCE or iSCSI function on the adapter.
WWPN
WWPN of any FC/FCoE function on the adapter