Dell Emulex Family of Adapters - Manual (Page 388)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
iSCSI Commands
388
SetTargetProperties
This command sets the ETO value of a target.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetTargetProperties
Parameters
SetTPLoginProperties
This command sets a target portal’s login properties. This command requires that you
specify a valid IPv4 or IPv6 Target IP and Port . However, if you
specify no options other than the Target IP and Port, no changes are made. You must
change at least one of the optional parameters for this command to make any changes
to the target portal's login properties.
These properties are used when discovering the targets on the target portal. The targets
inherit the target portal's properties when they are discovered. Targets already
discovered do not inherit the updated properties, only newly discovered targets inherit
the properties.
When you set the authentication method to a value other than 0, you must set
additional parameters. Each string should be enclosed in quotations to avoid
mishandling by the Windows, Linux, Solaris, or VMware shell’s parser.
DataDigest
0 = None (default)
1 = CRC32C
Auth
0 = None (default)
1 = One-Way CHAP
2 = Mutual CHAP
TgtCHAPNam
Target CHAP name enclosed in quotes (string length: 1–256).
TgtSecret
Target Secret enclosed in quotes (string length: 12–16).
InitCHAPName
Initiator CHAP name enclosed in quotes (string length: 1–256).
InitSecret
Initiator Secret enclosed in quotes (string length: 12–16).
MAC_Address
The MAC address of an iSCSI port.
iscsi_target_name
Target’s iSCSI name enclosed in quotes (string length: 11–255).
ETO
The extended timeout option for the target:

For Windows, valid values are 0–3600

For Linux, Solaris, and VMware ESXi, valid values are
0–30