Dell Emulex Family of Adapters - Manual (Page 1235)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
6. Managing Adapters and Ports
iSCSI Port
1235

MaxConnections – The maximum number of connections to targets that are
allowed within a single session.

MaxOutstandingR2T – The maximum number of outstanding request to
transmits (R2Ts) per task within a session, each up to MaxBurstLength bytes.

FirstBurstLength – The maximum amount of unsolicited data (in bytes) the
initiator can send to the target during the execution of a single iSCSI command.

MaxBurstLength – The maximum amount of either unsolicited or solicited data
the initiator may send in a single burst. Any amount of data exceeding this
value must be explicitly solicited by the target.

DefaultTimeToWait – The minimum time to wait, in seconds, before the
initiator attempts to reconnect or reassign a connection (or task) that has been
dropped after an unexpected connection termination or reset. The initiator and
target negotiate to determine this value.

DefaultTimeToRetain – The maximum time, in seconds, to reassign a
connection after the initial wait that is indicated in DefaultTimeToWait has
elapsed. The initiator and target negotiate to determine this value.

ErrorRecoveryLevel – The operational ErrorRecoveryLevel for the session. 0
indicates recovery only by session restart. 1 indicates recovery by reissuing
commands, data, or status. 2 indicates connection failure recovery.

DataPDUInOrder – The order of PDUs within a sequence.

DataSequenceInOrder – The order between sequences.
Session Statistics Area

Session Direction – The direction of iSCSI session. Valid values are
InboundSession and OutboundSession.

Cmd PDUs – The count of Command PDUs transferred on this session.

Response PDUs – The count of Response PDUs transferred on this session.

Xmt Data Octets – The count of data octets that were transmitted by the local
iSCSI node on this session.

Recv Data Octets – The count of data octets that were received by the local iSCSI
node on this session.

Digest Errors – The count of PDUs which were received on the session and
contained header or data digest errors.

Connection Timeouts – The count of connections within this session which have
been terminated due to a timeout.

Session Target Alias – The target alias for the session.
Connection Information Area

iSCSI Connection ID – The iSCSI Connection ID assigned to the connection.

Status – The status of the connection. Valid values are connected and unknown.

Source IP Address – The source IP address for the connection.

Source Port – The source TCP port number for the connection.

Destination IP Address – The destination IP address for the connection.