Dell Emulex Family of Adapters - Manual (Page 1289)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
6. Managing Adapters and Ports
OCe14100–Series Adapters
1289

Error – The FCoE Error status. The error status indicates whether an error
occurred during the configuration exchange with the peer. Error is also set to
Yes when the Compatible method fails.
FCoE and iSCSI Protocol Properties Area

State – Enabled indicates that there is flow control in both directions (receive
and transmit).

Sync’d – If Yes, the PFC priorities have been set by the peer. This parameter
cannot be set.

Error – The FCoE Error status. The error status indicates whether an error
occurred during the configuration exchange with the peer. Error is also set to
Yes when the Compatible method fails.

iSCSI Priority (if applicable) – The configured iSCSI priority.

FCoE Priority (if applicable) – The configured FCoE priority.
ETS Properties Area

State – The protocol state. It can be Enabled or Disabled.

Sync’d – If Yes, the protocol priority has been set by the peer. This parameter
cannot be set.

Error – The error status. The error status indicates whether an error occurred
during the configuration exchange with the peer. Error is also set to Yes when
the Compatible method fails.

Active Groups Table

Group ID – The Priority Group number. It can be 0 to 7.

Priority Membership – The priorities that are assigned to each Priority
Group. It is represented in comma separated format.

Bandwidth% – The percentage of available link bandwidth allocated to a
particular Priority Group.
DCB Tab Button
The Configure DCB button allows you to configure the DCB parameters.
Configuring DCB Parameters for FCoE/iSCSI Adapter Ports
To configure DCB parameters for a physical port:
1. Select a host in the vSphere console tree-view and select the Emulex OneCommand
tab.
2. In the Emulex Device Management tree-view, select the physical port whose DCB
properties you want to configure.
3. Select the DCB tab.
4. Click Configure DCB. The DCB Configuration dialog box appears.
5. Configure the settings you want and click OK.