Dell Emulex Family of Adapters - Manual (Page 430)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Profile Management Commands
430
Port Assignments:
Port 1: NIC,iSCSI,FCoE,NIC
Port 2: NIC,iSCSI,FCoE,NIC
Reboot Configuration
Profile ID : 37
MC Type : NPAR
NParEP Mode : Enabled
Port Assignments:
Port 1 (p0): NIC,iSCSI,NIC,NIC,NIC,NIC,NIC,NIC
Port 2 (p1): NIC,iSCSI,FCoE,NIC,NIC,NONE,NONE,NONE
Note:(pN) labels are the port parameter names to use in the
SetAdapterPortConfig command (e.g. p0=NIC,FCoE p1=NIC,iSCSI).
Showing NPar Configuration Using CMGetParams
The CMGetParams command shows the current NPar configuration for an adapter's
physical port. When NPar is enabled, “CMGetParams” shows the function information
such as the protocol and bandwidths. See “CMGetParams” on page 342 for more
information.
When you are using NPar, this command displays the adapter's active (booted) mode
as NPar or None, the configured mode as NPar or None, and the available management
modes, which is NPar only. This is followed by a table showing the specified port's
functions and function properties. When NPar is active, the Type column shows the
protocol that is running on each function.
Examples Using CMGetParams
NPar Disabled
>hbacmd cmgetparams 00-00-c9-12-34-56
Active Mode: None
Configured mode: None
Available modes: NPAR
NPar Enabled — 4 Partition/Port
>hbacmd cmgetparams 00-00-c9-12-34-56
Active Mode: NPAR
Configured mode: NPAR
Available modes: NPAR
Func# Type MAC Address Min BW Max BW
----- ----- ----------------- ------ ------
0 NIC 00-00-c9-12-34-56 20 75
4 iSCSI 00-00-c9-12-34-57 60 100
8 FCoE 00-00-c9-12-34-58 40 100
12 NONE 00-00-c9-12-34-59 0 0