Dell Emulex Family of Adapters - Manual (Page 367)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Dump Commands
367
GetDumpDirectory
This command shows the dump file directory for the adapters in the host.
Notes

The dump directory can be set on VMware ESXi hosts only.

The dump directory applies to all adapters in the server. There is not a separate
dump directory for each adapter.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
GetDumpDirectory
Parameters
GetDumpFile
This command gets the dump file. For dump file retrieval over FC/FCoE, the WWPN
of a remote FC/FCoE port is required to access the remote host. This command gets the
user-specified dump file to the local client’s dump directory. The dump directory (local
and remote) is named Dump. The dump files are copied from the Dump directory of
the remote host to the Dump directory of the local host. Therefore, specifying a local
port identifier for this command returns the following error, since the source and
destination directory is the same.
ERROR: HBACMD_GetDumpFile: RM_GetDumpFile call failed (2)
ERROR: <2>: Not Supported
Dump directory:

For Windows – C:\Program Files\Emulex\Util\Dump

For Linux – /var/opt/emulex/ocmanager/Dump

For Solaris – /opt/ELXocm/Dump

For VMware ESXi – The dump directory set using the SetDumpDirectory
command.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
GetDumpFile
WWPN
The WWPN of an FC or FCoE port.
MAC
The MAC address of the NIC or iSCSI port.