Dell Emulex Family of Adapters - Manual (Page 338)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Authentication Commands
338
InitiateAuth
This command initiates the authentication configuration on the adapter.
Supported By
Linux, Solaris, and Windows
Syntax
InitiateAuth
Parameters
SetAuthConfig
This command sets the authentication configuration for the adapter.
Supported By
Linux, Solaris, and Windows
Syntax
SetAuthConfig
Note: Where multiple parameters and values are used, separate them using commas.
Parameters
WWPN1
The WWPN of an FC port.
WWPN2
Use “ff:ff:ff:ff:ff:ff:ff:ff” for a switch or use the WWPN for a target.
WWPN1
The WWPN of an FC port.
WWPN2
Use “ff:ff:ff:ff:ff:ff:ff:ff” for a switch or use the WWPN for a target.
PasswordType
1 = ASCII
2 = Hex (binary)
3 = Password not yet defined
Password
The current password value.
Param
The parameter names:

Mode

Timeout

Bi-directional

Hash-priority

DH-priority

Re-authentication

Re-authentication-interval