Dell Emulex Family of Adapters - Manual (Page 959)

Emulex Drivers Version 10.2 for Linux User Manual P010081-01A Rev. A
4. Troubleshooting
Log Messages
959
INTx Request IRQ failed – err
The request for INTx interrupt registration failed.
The driver is non-functional if the INTx interrupt
cannot be registered. Error
Invalid cookie. FW image may
be corrupted
The firmware image under
/lib/firmware/ does not have the
expected cookie. The firmware in this file will not
be flashed. Copy the proper file and try flashing
again. Error
Invalid mailbox completion
The driver received an unexpected completion
status for a firmware command. Error
Link down/Link up
This is an informational message about a change in
Link status. Information
LPVID
VLAN filter configured in BIOS in multichannel
configuration. Information
Mac address assignment
failed for VF
MAC M set on VF
Failed
Firmware command fails to add a MAC address to a
virtual function during initialization, or when
requested. Error
MAC address change to
failed
Failed to change to new MAC address as requested. Warning
Max: txqs
rss
Max: uc-macs
An information message logging maximum resources
available to the function. TX rings, RX rings, RX
rings with RSS capability, number of VFs supported,
unicast MACs, multicast MACs and VLAN filters,
respectively. Information
Memory allocation failure
while flashing
The driver could not allocate memory required for
flashing the firmware image. Try flashing later. If
this issue persists, try flashing after a system
reboot. Error
Module param rx_frag_size
must be 2048/4096/8192.
Using 2048
An unsupported receive buffer size was passed for
the rx_frag_size module parameter. The driver
ignores the specified value and uses the default RX
buffer size of 2048. Warning
MSIx enable failed
Request for enabling MSIx interrupts registration
failed. Driver will then use INTx interrupts. Warning
MSIX request IRQ failed –err
The request for MSI-X interrupt registration failed.
The driver will use INTx interrupts. Warning
MTU changed from to
bytes
This is an informational message that the MTU value
changed as requested. Information
MTU must be between 256 and
9000 bytes
Request to change the MTU was issued with an
invalid MTU value. The request failed and MTU will
not be changed. Warning
opcode - failed:
status
A firmware command with opcode failed with the
indicated status code and extended status code. Error
Table 4-5 Ethernet Driver Log Messages of Type (Continued)
Ethernet Log Message Description Type