Dell Emulex Family of Adapters User Manual

Page 431

OneCommand Manager Command Line Interface Version 10.2 User Manual

P010067-01A Rev. A

5. CLI Client Command Descriptions

Profile Management Commands

431

NPar Enabled — 8 Partitions/Port

>hbacmd cmgetparams 00-00-c9-12-34-56

Active Mode: NPAR

Configured mode: NPAR

Available modes: NPAR

Func# Type MAC Address Min BW Max BW

----- ----- ----------------- ------ ------

0 NIC 00-00-c9-12-34-56 10 50

2 iSCSI 00-00-c9-12-34-57 20 100

4 NIC 00-00-c9-12-34-58 10 50

6 FCoE 00-00-c9-12-34-59 30 100

8 NIC 00-00-c9-12-34-5A 10 50

10 NIC 00-00-c9-12-34-5B 10 50

12 NIC 00-00-c9-12-34-5C 10 50

14 NIC 00-00-c9-12-34-5C 0 50

NParEP Mode

When using NPar adapters, you can change the total number of partitions displayed

and configured on the adapter to 8 when the NParEP Mode property is disabled or to

16 when the NParEP Mode property is enabled. Use the “nparepmode” parameter in

the SetAdapterPortConfig command to enable or disable this property.

Notes:



When NPar is disabled, NParEP Mode is automatically disabled too. It is not

necessary to specify the “nparepmode” parameter on the command line when

disabling NPar by setting the “mctype” parameter to “None”.



After enabling or disabling NParEP Mode with the SetAdapterPortConfig

command, default bandwidths will be automatically assigned to each partition

more information.

Parameters

MAC

MAC address of any iSCSI, NIC or NIC+RoCE partition on the adapter.

WWPN

WWPN of any FCoE partition on the adapter

nparepmode 1 = enable the NParEP Mode to display and configure 16 functions.

0 = disable the NParEP Mode to display and configure 8 functions only.