Dell Emulex Family of Adapters - Manual (Page 426)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Profile Management Commands
426

RoCE cannot be specified for any multichannel configurations.

This command fails under the following conditions:

Two storage protocols are specified for f1 and f2 and concurrent storage
mode is not available.

Three storage protocols are specified on a port.

The f2 and f3 storage protocols are the same.

For mixed mode, f2 through fm must be NIC or “None”.

For concurrent mode, f3 must be NIC or “None”.

The optional “mctype=” parameter can specify the multichannel type or be set
to "None" to disable multichannel. If the “mctype=” parameter is not specified,
the currently configured multichannel type is not changed.
Note: You must reboot your system after executing this command to run the new
protocols assigned to the channels.
Examples
Mixed Mode - UMC 4 Port, 4 Channels/Port
>hbacmd SetAdapterPortConfig 00-00-c9-12-34-56 p0=nic,iscsi,nic,nic
p1=nic,fcoe,nic,nic p2=nic,fcoe,nic,nic p3=nic,iscsi,nic,nic
mctype=umc
Successfully changed port configuration. A reboot is required to
complete changes.
>hbacmd GetAdapterPortConfig 00-00-c9-12-34-56
Number of Ports : 4
Maximum FCoE Functions : 4
Maximum iSCSI Functions : 4
Mixed Mode I/O Allowed : Yes
Concurrent Mode I/O Allowed : No
ROCE Functions Allowed : Yes
RebootRequired : Yes
Active Configuration
Profile ID : 37
MC Type : UMC
Port Assignments:
Port 0: NIC,NIC,NIC,NIC
Port 1: NIC,NIC,NIC,NIC
Port 2: NIC,NIC,NIC,NIC
Port 3: NIC,NIC,NIC,NIC
Reboot Configuration