Dell Emulex Family of Adapters - Manual (Page 222)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
OCe14000-Series Adapters
222
personality. In this case, after clicking the Apply button, the tab switches to the
single personality view and the selected personality is shown in the personality
pull-down menu.
Configuring RoCE in a Custom View
In Custom view, NIC + RoCE can be configured on the first function of a port. After
checking Configure NIC + RoCE, only the first function of each port is available and
you can select NIC + RoCE or just NIC to run on each port. Storage functions cannot be
configured when any of the ports on the adapter are configured to run NIC + RoCE.
You must also choose a RoCE configuration (i.e. profile) from the list below the port
table.

Choose the RoCE-2 profile for SMB Direct on Windows Server 2012 and
Windows Server 2012 R2 from the pull-down menu in the NIC + RoCE
Configuration box.
Note: Check the Implementer's Lab on the Emulex website for any updated
information on additional use cases for the RoCE-2 profile.

For the RoCE-1 profile, check the Implementer's Lab on the Emulex website for
any updated information on use cases for the RoCE-1 profile.
Note: RoCE configurations are not supported with SR-IOV.
Figure 8-77 Custom NIC + RoCE Configuration