Dell Emulex Family of Adapters - Manual (Page 1451)

Boot for the Fibre Channel Protocol User Manual P010096-01A Rev. A
6. EFIBoot
Configure Boot Parameters
1451
To change the device path:
1. On the Boot Configuration menu, select 1, Device Path Selection and press
. The screen shown in Figure 6-15 is displayed.
Figure 6-15 Device Path Screen
2. Use the up/down arrows to change the path and press . The screen is
refreshed with the new value.
The device path is typically not changed. The SCSI device path is used for legacy
systems.
3. Press to return to the EFI utility menu.
Change the Maximum LUNs per Target Setting
The maximum number of LUNs represents the maximum number of LUNs that are
polled during device discovery. The minimum value is 1, the maximum value is 4096.
The default is 256.
To change the maximum number of LUNs:
1. On the Boot Configuration menu, select 2. Maximum LUNs/Target and press
. The screen shown in Figure 6-16 is displayed.
Figure 6-16 Current Maximum LUNs Screen
2. Use the up/down arrows to change the maximum LUN value (between 1 and 4096)
and press . The screen is refreshed with the new value.