Dell Emulex Family of Adapters - Manual (Page 1600)

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
9. Configuring and Managing the iSCSI Initiator with the iSCSISelect Utility
Selecting a Controller
1600
name on this menu so that the iSCSI Initiator Name on all the controllers
match. If there were pre-existing sessions before the iSCSI Initiator Name
change, the pre-existing sessions use the original name that was used to
login the very first time. The new name is used for any sessions added after
the name change.
3. Select Save and press to save the iSCSI initiator name. If you select
Controller Configuration without saving the changes, a warning message will
appear stating that your settings will be lost and asking whether you want to cancel
or not. Press and you will lose your changes. Press and you will return to
the iSCSI Initiator Configuration screen.
Selecting a Controller
After you configure an ISCSI initiator name, select a controller to configure the iSCSI
target. If you are running the iSCSISelect utility with multiple controllers, all the
controllers are listed in the Controller Selection menu. Figure 9-2 is an example of the
Controller Selection menu.
Figure 9-2 Controller Selection Menu
After you select the controller, the Controller Configuration menu appears. From this
menu, you can configure and manage the iSCSI initiator and targets.
Figure 9-3 Controller Configuration Menu
If you are not sure that you are configuring the correct port, you can check by either:

Performing port identification. For additional information, see “Identifying a
Port” on page 1609.

Checking the link status in the Network Configuration menu. Connect the
controller port to a 10 Gb/s switch port and check the link status in the Network
Configuration menu. If the status is Link Up, it is the correct controller port.
Note: Make sure you back out of the Network Configuration menu to the
Controller Configuration menu before checking the Network
Configuration menu. This allows the Link Status field to refresh when
you insert or remove the cable from the controller.