Dell Emulex Family of Adapters - Manual (Page 1486)

Boot for the Fibre Channel Protocol User Manual P010096-01A Rev. A
7. Configure EFIBoot via UEFI HII (Human Interface Infrastructure) in a UEFI 2.1 System
Configure Boot Parameters
1486
Note: Emulex 8 Gb/s adapters do not support 1 Gb/s link speed. Emulex 16 Gb/s
adapters do not support 1Gb/s or 2 Gb/s link speed.
The screen is refreshed with the new value.
4. Press to return to the EFI utility menu.
5. Select Commit Changes and press .
Configure Boot Parameters
You can change the:

Maximum LUNS/targets

Boot target scan method

Device discovery delay
Change the Maximum LUNs per Target
The maximum number of LUNs represents the maximum number of LUNs that are
polled during device discovery. The minimum value is 1, the maximum value is 4096.
The default is 256.
To change the maximum number of LUNs:
1. From the Adapter Selection screen, select the adapter whose maximum LUNs per
target information you want to change and press .
2. From the Configure Boot Parameters menu, navigate to Maximum LUNs/Target
and press . The screen becomes editable.
Figure 7-18 Maximum LUNs/Target Screen