Dell Emulex Family of Adapters - Manual (Page 257)

OneCommand™ Manager Application P010066-01A Rev. A
11. Configuring Boot from an FC SAN
Boot Device Parameters
257

Auto (default)

1 Gb/s (if available)

2 Gb/s (if available)

4 Gb/s (if available)

8 Gb/s (if available)

16 Gb/s (if available)
7. If you want, click Advanced Settings to configure autoscan, spinup delay and so
on. See “Configuring Advanced Settings (Boot from SAN)” on page 259 for more
information.
8. For x86 and EFIBoot, select one or more boot devices. For OpenBoot, select only one
boot device.
9. Do one of the following on the Boot from SAN Configuration window:

Select Target WorldWide Port Names, type the numbers and click OK.

Select Target D_ID, type the numbers and click OK.

Select Target LUN, type the number and click OK.

For EFIBoot and OpenBoot, type in an 8-byte LUN (hex) and a target ID for
the LUN. Also, you must enter the LUN value in “big endian”
(most-significant byte, or “big end” first) order and enter all 16 characters
including leading zeroes.

Click Select from List, select the target from a list of discovered LUNs (if
available) and click OK on the Select Boot Device window. While you can
manually enter the target and LUN from the Boot from SAN Configuration
dialog box, it is easier to select an existing LUN from this window. (See Figure
11-2.) The OneCommand Manager application attempts to update the boot
parameters. If successful, a window appears with a confirmation message. Click
OK on this confirmation window.