Dell Emulex Family of Adapters - Manual (Page 178)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
iSCSI
178

Group ID – The Priority Group ID.

Priority Membership – The configured priority membership grouping.

Bandwidth % – The configured value of bandwidth for the different Priority
Groups.

Max Configurable PGs – The maximum number of Priority Groups that can
be configured.
Configure DCB Dialog Box Buttons

Defaults – Click to return parameters to default iSCSI DCB settings.

Configuration Rules – Click to display the iSCSI Priority window that lists the
rules for configuring iSCSI priorities.
You must observe the following rules when configuring priority groups for
iSCSI adapter ports:
1. Only one priority can be configured as the iSCSI priority.
2. A maximum of two PFC priorities can be selected and one of them must
match the iSCSI priority.
Note: Not all adapters support two PFC priorities. Adapters that do not
support two PFC priorities display an error message if you try to
configure more than one PFC priority.
3. The priority group to which the iSCSI priority is assigned must contain no
other priorities.
4. The additional PFC priority must be assigned to a priority group which has
no other priorities.
5. Bandwidths of all the priority groups must add up to 100%.

OK – Click to apply and save your changes.

Cancel – Click to discard any changes you made.
Configuring iSCSI Port Initiator Login Options
The iSCSI Initiator Login Options dialog box enables you to configure the set of login
options used by the iSCSI initiator when logging into a target portal or by the target
portal when it is discovering targets. The discovered targets inherit the login options
used during this discovery. Target portals discovered via iSNS also use these login
options. The dialog box contains the initiator iSCSI Qualified Name (IQN) and fields for
manually entering the IQN and an optional initiator alias. Initiator login options are