Dell Emulex Family of Adapters - Manual (Page 347)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Channel Management Commands
347
Configured mode: UMC
Available modes: UMC
Func# Type MAC Address LPVID Min BW Max BW
----- ----- ----------------- ----- ------ ------
0 NIC 00-00-c9-12-34-56 2 25 50
2 iSCSI 00-00-c9-12-34-57 n/a 50 100
4 NIC 00-00-c9-12-34-58 3 0 0
6 NIC 00-00-c9-12-34-59 4 25 50
CMSetLPVID
This command sets the LPVID values for the UMC and SIMode NIC channels. Use the
CMGetParams command to determine the number of LPVIDs required. See
“CMGetParams” on page 342 for more information. A reboot is not required for these
changes take effect when UMC is enabled
Note: When the current multichannel mode is not UMC or SIMode, the CMSetLPVID
command fails.
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
CMSetLPVID ... [LPVIDn]
Parameters
Considerations for Using CMSetLPVID

LPVID values are in the range of 2-4094.

Every NIC channel on a physical port must have a unique LPVID.

For FCoE and iSCSI channels, ‘0’ must be entered because LPVIDs can only be
specified for NIC channels.

LPVIDs specified for channels with protocols set to "None” are ignored.

This command is not supported on 1 Gb ports.
WWPN
WWPN of an FCoE function on the physical adapter port.
MAC
MAC address of any NIC or iSCSI function on the physical adapter
port.
LPVID0
LPVID for channel 0.
LPVID1
LPVID for channel 1.
LPVIDn
LPVID for channel n.