Dell Emulex Family of Adapters User Manual
Page 936
Emulex Drivers Version 10.2 for Linux User Manual
P010081-01A Rev. A
4. Troubleshooting
Log Messages
936
1477: Failed to set up hba
Failed to set up the HBA.
Data:
None
Severity: Error
Log:
LOG_INIT
Action:
None required.
1603: Loopback test did not receive expected data length. actual length
The loopback test did not receive the same amount of data that it transmitted.
Data:
None
Severity: Error
Log:
LOG_LIBDFC
Action:
None required.
1800: Could not issue unreg_vpi
Driver attempt to unregister VPI failed.
Data:
None
Severity: Error
Log:
LOG_VPORT verbose
Action:
Software driver error. If this issue persists, report these errors to Technical Support.
1801: Create vport work array FAILED: cannot do scsi_host_get
The driver was unable to get a reference to a SCSI host.
Data:
None
Severity: Warning
Log:
LOG_VPORT verbose
Action:
Software driver warning. If this issue persists, report these errors to Technical Support.
1816: FLOGI NPIV supported, response data
The fabric reports support for NPIV upon FLOGI.
Data:
(1) response_multiple_NPort
Severity: Warning
Log:
LOG_VPORT verbose
Action:
No action needed, informational.
1817: Fabric does not support NPIV - configuring single port mode
The fabric reports no support for NPIV upon FLOGI.
Data:
None
Severity: Warning
Log:
LOG_VPORT verbose
Action:
No action needed, informational.
1818: VPort failed init, mbxCmd status> , rc = A pending mailbox command that was issued to initialize the port failed. Data: (1) mbxCommand (2) mbxStatus (3) rc Severity: Error LOG_VPORT verbose Action: Software driver error. If this issue persists, report these errors to Technical Support. Table 4-4 LPFC Error Log Messages and their Descriptions (Continued)
Log: