Setdcbpriority – Dell Emulex Family of Adapters User Manual
Page 1376
OCM for VMware vCenter Version 10.2 User Manual
P009805-01A Rev. A
11. Using OneCommand Manager for VMware vCenter Command Line Interface
The Command Reference
1376
Default – Setting the SetDCBParam arguments to default sets all UCNA DCB
parameters (including priority groups) to their default values.
Example:
elxvcpcmd setdcbparam
Link Layer Discovery Protocol (LLDP) Parameters and Values
(1= enabled 0 = disabled)
TxState (Transmit State) – DCBX uses Link Layer Discovery Protocol (LLDP) to
exchange parameters between two link peers. For the DCBX protocol to operate
correctly, both LLDP Rx and Tx must be enabled. If either Rx or Tx is disabled,
DCBX is disabled.
RxState (Receive State) – DCBX uses LLDP to exchange parameters between
two link peers. For the DCBX protocol to operate correctly, both LLDP Rx and
Tx must be enabled. If either Rx or Tx is disabled, DCBX is disabled.
TxPortDesc (Transmit Port Description) – Provides a description of the port in
an alpha-numeric format. The value equals the ifDescr object, if the LAN device
supports RFC 2863.
TxSysDesc (Transmit System Description) – Provides a description of the
network entity in an alpha-numeric format. This includes the system's name
and versions of hardware, operating system and networking software
supported by the device. The value equals the sysDescr object, if the LAN
device supports RFC 3418.
TxSysName (Transmit System Name) – Provides the system's assigned name in
an alpha-numeric format. The value equals the sysName object, if the LAN
device supports RFC 3418.
TxSysCap (Transmit System Capabilities) – Indicates the primary function(s) of
the device and whether or not these functions are enabled on the device. The
capabilities are indicated by two octets. Bits 0 through 7 indicate Other,
Repeater, Bridge, WLAN AP, Router, Telephone, DOCSIS cable device and
Station respectively. Bits 8 through 15 are reserved.
Where multiple values are possible, specify them with a comma-separated list.
Example:
elxvcpcmd v=12.345.678.901 u=username p=password h=12.345.678.123
setdcbparam 00-00-c9-3c-f7-88 fcoepriority 3
setdcbpriority
Syntax
elxvcpcmd.exe v=
h= PGID0> < Priorities of PGID1>...