Dell Emulex Family of Adapters - Manual (Page 339)

OneCommand Manager Command Line Interface Version 10.2 User Manual P010067-01A Rev. A
5. CLI Client Command Descriptions
Authentication Commands
339
SetPassword
This command sets the password on the adapter for an authenticated connection to the
switch.
Supported By
Linux, Solaris, and Windows
Syntax
SetPassword
Parameters
Value
The value is based on the type of :

Mode: disabled, enabled, or passive

Timeout: time in seconds

Bi-directional = disabled or enabled

Hash-priority: md5 or sha1 (md5 = first md5, then sha1;
sha1 = first sha1, then md5)

DH-priority: 1, 2, 3, 4, 5; any combination up to 5 digits

Re-authentication: disabled or enabled

Re-authentication-interval: 0, 10– 3600
WWPN1
The WWPN of an FC port.
WWPN2
Must be “ff:ff:ff:ff:ff:ff:ff:ff” for a switch or the actual WWPN for a target.
Flag
1 = Local (password used by the adapter when the adapter authenticates
to the switch)
2 = Remote (password used by the adapter when the switch authenticates
to the adapter)
Cpt
Current password type.
1 = ASCII
2 = Hex (binary)
3 = Password not yet defined
Cpw
Current password value.
Npt
New password type.
1 = ASCII
2 = Hex (binary)
Npw
New password value.