Setinitiatorproperties – Dell Emulex Family of Adapters User Manual
Page 384
OneCommand Manager Command Line Interface Version 10.2 User Manual
P010067-01A Rev. A
5. CLI Client Command Descriptions
iSCSI Commands
384
SetInitiatorProperties
This command sets the initiator properties for the specified port. It allows you to
specify an initiator name
you opt not to specify these fields, a default iSCSI name is assigned.
Except for the
set as the target portal’s login properties to be used when discovering the targets on the
target portal. The targets inherit the target portal's properties when they are
discovered. The discovered target's login properties can be changed using the
SetTargetProperties command.
When you set the authentication method
additional parameters. Each string should be enclosed in quotations to avoid
mishandling by the Windows, Linux, Solaris, or VMware shell’s parser. Additionally,
these properties are used for iSNS target discovery to set the discovered target's login
properties.
If you set the authentication method to “One-Way CHAP” (
must also specify the “Target CHAP Name” and “Target Secret.” For example:
hbacmd SetInitiatorProperties 00-11-22-33-44-55 Auth=1
"TgtChapName" "TargetSecret1"
If you set the authentication method to “Mutual CHAP” (
specify all four values. For example:
hbacmd SetInitiatorProperties 00-11-22-33-44-55 Auth=2
"TgtChapName" "TargetSecret1" "InitCHAPName" "InitialSecret1"
Supported By
Linux, Solaris, VMware ESXi, and Windows
Syntax
SetInitiatorProperties
[Initiator_Alias="initiator_alias"] [ImmediateData=<0|1>]
[HeaderDigest=<0|1>] [DataDigest=<0|1>] [Auth=<0|1|2> "TgtCHAPName"
"TgtSecret" "InitCHAPName" "InitSecret"]
TSIH
TSIH value of the session. The possible values are 1–65535.
ISID_Qual
Target_IP
ISID qualifier of the session. The possible values are 0–65535. You
can specify an IPv4 or IPv6 Target IP address that the target is using
depending on the adapter type.
0|1
Specifies the state of the BootProperty for the target:
0 = Disabled
1 = Enabled