Dell Emulex Family of Adapters - Manual (Page 215)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
OCe14000-Series Adapters
215

TX Output Power – The measured TX output power.

RX Input Power – The measured RX input power.
OCe14000-Series Adapters
Configuring OCe14000-Series Adapters
When you select an OCe14000-series adapter from the discovery-tree, the Adapter
Configuration tab is displayed. The type of information that appears depends on the
what protocols and capabilities are available on the adapter. (The IPL defines the
protocols and capabilities.)
For all adapters except NPar, there are three configuration modes available:

Single personality – Select a single protocol (along with NIC, or NIC-only) to
run on all ports on the adapter.

Custom – Choose the protocols to run on each port independently.

Multichannel – View the channel properties and change the configurable
properties (based on the multichannel type).
Note: For NPar, the adapter is either running with NPar disabled (meaning the
adapter is running as a single NIC or NIC + RoCE function on each port), or
with NPar enabled, which is similar to a multichannel configuration. See “Dell
NPar Configuration View” on page 228 for more information.
Note: RoCE configurations are not supported with SR-IOV.