Dell Emulex Family of Adapters - Manual (Page 154)

OneCommand™ Manager Application P010066-01A Rev. A
8. Managing Adapters and Ports
FC/FCoE
154
Setting Driver Parameters for All Adapters in a Host
To change the driver parameters for all adapters installed in a host:
1. Do one of the following:

From the View menu, click Group Adapters by Host Name.

From the toolbar, click Group Adapters by Host Name.
2. In the discovery-tree, click the host whose adapter driver parameters you want to
change.
3. Select the Host Driver Parameters tab. If there are adapters with different driver
types installed, the Installed Driver Types menu shows a list of all driver types and
driver versions that are installed. Select the driver whose parameters you want to
change. This menu does not appear if all the adapters are using the same driver.
4. In the Host Driver Parameters tab, click the parameter that you want to change. A
description of the parameter appears on the right side of the tab.
Figure 8-28 Host Driver Parameters Tab – Host Selected
5. Enter a new value in the Value field in decimal or hexadecimal format, depending
on how the current value is presented. If the value is in hexadecimal format, it is
prefaced by “0x” (for example -”0x2d”).
6. To make a change temporary (the parameter to revert to its last permanent setting
when the system is rebooted), check Make changes temporary. This option is
available only for dynamic parameters.
7. To make changes to multiple parameters, check Make all changes temporary. Only
dynamic parameters can be made temporary.
8. Click Apply.