Dell Emulex Family of Adapters - Manual (Page 1312)

OneCommand Manager for VMware vCenter Version 10.2 User Manual P010089-01A Rev. A
9. Diagnostics
LightPulse FC HBA Diagnostic Tests
1312
Figure 9-4 D_Port Tests Dialog Box
The D_Port tests are launched. If all tests pass, a dialog box similar to Figure 9-5 is
displayed. If all tests do not pass, the Failed result in shown in the Test Phase
Results. See Figure 9-6 for an example.
Click Save Results to File to save the test results to a text file. You can view this text
file in any text editor.
Notes

To stop tests, click Stop Test.

The D_Port tests can take an extended period of time to complete.

If the Overall Test Result is "FAILED", you need to either re-run the tests
successfully or reset the HBA port to bring the link back up.

If an older version of an SFP is used in an adapter's port, which does not fully
support all D_Port tests, some of the test phase results report skipped. If an
older SFP version is detected by the OneCommand Manager for VMware
vCenter, a message is displayed under the results box indicating that the SFP
version does not fully support all D_Port tests.

If a test phase fails, the D_Port diagnostics are automatically stopped. In this
case, some of the phases may not be reported in the results. However, the failed
phase will be reported.